Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Inner and outer tie rod replacement question 200 1981

posted by  DougC on  Fri Jan 17 13:40 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 10 08:30 CST 2014
[RELATED]

1981 with Cam Gear steering rack: I'm going to replace the right tie rod, inner and outer. Does anyone have any advice that might make the job smoother? I'm especially wondering about disconnecting the inner tie rod from the shaft that goes through the steering box. How much torque can this shaft take as I loosen the old inner tie rod end, and tighten the new one? Does it go on really tight? Also, I haven't done any outer tie rods yet either. This is a first for me. Any advice is appreciated. Thanks.
--
Thanks to everyone for the help, Doug C.
81 242 Brick Off Blocks, stock
86 240, 129K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Inner and outer tie rod replacement question [200][1981]
posted by  DougC  on Fri Jan 17 13:40 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.