Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

License Plate Light Bulb Replacement 200 1989

posted by  Eric-S on  Mon Jan 27 12:07 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Both of my bulbs finally decided to bite the bullet and burn out. Both houses have a few broken tabs and each are currently being held up by some black electrical tape.

What's the easiest way to replace the bulbs? I tried to (somewhat gently) pull down on one of the housings to get to the bulb, although it didn't budge, I didnt't want to completely break the housing off. Bentley says that you have to carefully remove the lens by prying into a notch. I didn't see one. Does anyone have any pointers they'd like to share? If there is a notch, what location would it be in? Thanks.
--
Regards,
Eric Staufer,
'89 244DL 118k
My 240 Page






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New License Plate Light Bulb Replacement [200][1989]
posted by  Eric-S  on Mon Jan 27 12:07 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.