Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

in-tank pre-pump mounting? 200 1989

posted by  greg_mustang on  Tue Jan 28 01:32 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

I recently received a collection of parts to re-new the in-tank assembly in my '89 240 DL sedan. With respect to a few diagrams from a repair manual, I notice the pre-pump is typically attached (mounted) to the bottom of the sending unit with a bracket and a screw (also to connect the ground to the pump motor). I am missing this bracket, it didn't come with either the pre-pump I bought (scan-tech - FCP Groton) or the sending unit (FCP Groton).

Can I assume that the fuel hose that connects the pre-pump to the sending unit fuel line is not adequate to hold the pump in place? Should I expect to be able to re-use the mounting hardware from my original old assembly after I remove it from the car? Does this mount do the jo of correctly positioning the height of the pre-pump within the tank?

Awaiting your advice,
Thanks in advance.

Greg Mustang





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New in-tank pre-pump mounting? [200][1989]
posted by  greg_mustang  on Tue Jan 28 01:32 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.