Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

plasic fitting for turbo housing that goes to waste gate hose-availibility? 700 1989

posted by  someone claiming to be Scott on  Tue Jan 28 03:15 CST 2003 [RELATED]

The engine on the 740ti did a cut off due an over boost condition,and for good reason;the plasic fitting on the turbo housing came out and won't stay in.I am looking for a source other than buying a complete rebuild kit from the dealer.Also, I put a pressure pump on the hose that leads to the stock boost gauge and the fuel cut switch at the intake manifold,if my gauge is correct the boost cut off is around 12psi;which is at the end of the yellow zone on the stock boost gauge.Is 10 psi safe for for a stock engine with proper fuel ratio?







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.