Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Doing a head gasket, need, desire, crave parts advice 200

uid 13809's pic
posted by  Alex Z on  Tue Jan 28 19:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 3 04:30 CST 2013
[RELATED]

So. It's time to do a headgasket on the 85.. since I'm going to pull the head, repair a few of the (spark plug, etc) threads, get it flea dipped, etc.

But what should I do about the gaskets and head bolts? Of course I'm fearful of ScanTech parts, but they're so cheap. Actually, Nick at FCP Groton seems to have reasonable prices on a gasket set made up of Elring gaskets. I've seen some suggestions that the ST set is okay, just get xyz brand of head gasket. Felpro? Volvo?

What about the head, exhaust manifold, turbo, etc bolts? Stick with Volvo? Go cheap? I'd like to not do this job again anytime soon. :)

- alex

'85 244 Turbo
'84 245 Turbo






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Doing a head gasket, need, desire, crave parts advice [200]
posted by  Alex Z  on Tue Jan 28 19:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.