Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Axle bushing bracket bent 200

posted by  dash on  Sat Mar 1 14:46 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 19 08:01 CST 2008
[RELATED]

Another setback just when I thought I had solved a problem. I looked closely tonight at the outer axle bracket that the bushing wouldn't go into and lightly tapped the bushing. Hey it looks like it moved, it's not deformed and the edge is now lined up with the hole. So I put the tool together, start cranking and sure enough the bushing starts to go in the hole but then I notice the worst possible thing; the spacer that keeps the brackets parallel had fallen out earlier and I forgot to put it back in. So now, the outer bracket is bent inward about 1/8".

It doesn't seem to want to bend back by tapping it. Is there anything I can do or should I leave it to the professionals?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Axle bushing bracket bent [200]
posted by  dash  on Sat Mar 1 14:46 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.