Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Idling fine if IAC-valve is disconnected electrically... 200 1989

posted by  Frodo on  Sun Mar 2 23:53 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I have a 89 B230F LH2.4 which idles between 1200-1700rpm (surging).
Have not found any vacuum leaks yet.
Tired of checking diagnose output, mostly giving codes like 1-1-3, 2-2-1, 2-3-2 (too lean mixture).
I know that 016 AMM might be the problem, but I don't have a spare yet. (AMM voltage before start 1.3V, idling 2.3-2.6V depending on RPM)
O2 voltage mostly 0.5V
Hot air is disconnected (even if temperatures is mostly around 0'C).

If I disconnect the voltage to the IAC-valve, the idling goes down to a steady 1000 rpm.

Why is idling fine when IAC valve is disconnected? Is the ECU oscillating the IAC output? No change in idling when IAC is reconnected after start. Engine running fine when driving.

If I pull the power to the ECU the engine idles rough and somethimes dies, but after some trips runs fine again. I guess this is a limited "learning" period.
When swapping AMM, should ECU be reset to remove old data?

Frode P. Bergsager
Norway
--
Frodo 240GL 89 LH2.4







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.