Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AMM & O2 sensor checks 200 1986

posted by  darmstrong on  Sat Mar 8 02:55 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 13 12:21 CST 2014
[RELATED]

I tested some LH 2.2 component specs according to Bentley's and got the following:

Item spec my result

AMM heated wire 3.5-4 ohms 2.8 ohms
ambient impedance

oxygen sensor 0.4-1.0 volts .2 - .7 volts (Digital Multimeter)
voltage out

Also, manual suggested pulling oil dipstick should affect O2 sensor voltage, but I couldn't see an effect.


Is the low AMM reading typical of worn-out units, and does this definitely point to need for replacement?

Does low O2 output, or failure for dipstick pull to affect output indicate need for replacement of O2 sensor?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AMM & O2 sensor checks [200][1986]
posted by  darmstrong  on Sat Mar 8 02:55 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.