Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How can I be sure that my front control arm bushing is shot? 200 1989

posted by  greg_mustang on  Mon Mar 10 09:06 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

240 DL sedan 1989 B230F 150K miles

I recently posted about a new loud clunk that is very apparent on my front driver's side suspension, especially as slow speed.

After explaining the symptoms and the fact that I recently replaced the tie rod ends and inspected the inner tie rods (steering no play) and that my lower ball joints were replaced last fall, I have the infamous control arm bushing problem.
Shaking the top of the shock tower (via spring) by hand revieled no play either.

I would like to get this done soon. Yes I always do all work myself. Before ordering and getting the bushings shipped, is there any way I can assure that this is indeed the source of my clunk? No I have nothing to indicate otherwise, just looking for some sort of diagnostic...

Regards,
Greg Mustang
Montreal, Canada.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How can I be sure that my front control arm bushing is shot? [200][1989]
posted by  greg_mustang  on Mon Mar 10 09:06 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.