Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Shrinking plastic or rubber mouldings 200

posted by  el doctor on  Tue Mar 11 14:05 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Has anybody had the same experience I'm having on my 86 240? Several of the body mouldings seem to have shrunk over the years and thus pull loose from the clips. An example is the piece that extends back from the rear mud flap. On one side of my car it appears to have shrunk about 1/2 inch. Also, the inside door mouldings (the ones that go all around the door opening) have shrunk too. Is there something that can correct this or do I just have to try to replace the moulding pieces? Thanks for your input!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Shrinking plastic or rubber mouldings [200]
posted by  el doctor  on Tue Mar 11 14:05 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.