Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Spring replacement.. 200

posted by  scogod on  Fri Mar 14 20:29 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

A quick question regarding replacement of the front coils (to install lowering coils). I've got a Bentley manual and it says to disconnect the tie rod end from the control arm. Since I don't have a press like it mentions, is it possible to swing the assembly out from the wheel well without disconnecting the tie rod end? Is there enough upward/downward play to swing the assembly out? Are there any other tricks or shortcuts not mentioned in the bible? I'm also planning on picking up the fancy IPD strut nut tool. Those tie rod ends seem like a real P.I.T.A to get back on.... and off for that matter.

thx...
Scott
'84 244Ti
Vancouver






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Spring replacement.. [200]
posted by  scogod  on Fri Mar 14 20:29 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.