Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Fuel Sender 700 1989

I have an 89 760 turbo wagon, and recently replaced the fuel sender, c/w in-tank pump. This cylindrical device works, but I am not convinced that I have lined up the unit properly. It should not take a 10 or 15 minute drive over a fairly rough road to send the needle to the full mark.
Any suggestions as to what might be wrong here? I noticed that the internal cylinder was below a retaining tab on the outer cylinder, and I thought that moving the inner above the tab would make things work just fine. Is that my mistake?
Your suggestions are much appreciated!
John Hunter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Sender [700][1989]
posted by  jrh  on Thu Mar 20 07:25 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.