Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Advice needed - DIESEL gurus 200 1984

posted by  someone claiming to be Christopher on  Thu Mar 27 08:49 CST 2003 [RELATED]

Hello-
I have an '84 264 diesel w/ approx. 105k original. The car runs very well but has recently developed a small coolant leak between the #1 and #2 cylinders at the head gasket. The head gasket also appears to be leaking oil back near the injection pump. As of yet, there is NO mixing of oil and water, and no more smoke than usual out the back (what smoke there is isn't white). My questions are: Since I'm planning on replacing the gasket, 1) Should I specify a certain type or brand of gasket to be used? and 2) Is there anything else I should "take care of" while this repair is being done? and, finally, 3)Is it necessary to get the head machined if the car has never overheated?
Thanks very much for any help, my apologies for the long post-

-Chris in Austin, TX






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Advice needed - DIESEL gurus [200][1984]
posted by  someone claiming to be Christopher  on Thu Mar 27 08:49 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.