Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Question about Frequency Valve on 240 Turbo 200 1983

posted by  edmartz on  Fri Mar 28 16:59 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jul 21 17:04 CST 2009
[RELATED]

Hi,
I have a question about the frecuency valve, Its about:

1. When cold, my car starts ok, the frequency valve buzzing

2. When is warm, I have to disconnect the Frequency Valve (I put a switch) because I have bad performance, black somoke, erratic idle, etc.

NOTE: I have disconnected the Oxygen Sensor Because its bad, and It Is hard to find the BOSCH #11038 on my country.

The point 2 starts this syntoms about 1 month ago, I have disconnected the Oxygen sensor about 6 months and I have no problem.

The question is:
1. On the cold condition, the Thermal Cut-Out Swich and Pressure Switch works? I read this sensors ground the pin 7 of the ECU but is this on the warm condition?

or the frequency valve is bad?


Excuse me of this dummy questions but I dont know where start to check...

Edwin






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question about Frequency Valve on 240 Turbo [200][1983]
posted by  edmartz  on Fri Mar 28 16:59 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.