Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Help with installing power to Amplifier through Firewall on 1989 Volvo 240 200

posted by  phishie on  Wed Apr 2 08:48 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hey everyone,

I recently purchased an AMP and sub to install on my 1989 Volvo 240 Sedan. To power the Amp I will have to run the power cable from the battery back to the trunk. I read some instructions on installing AMPs on www.crutchfield.com and it says you need to put it through a premade hole in the firewall or drill your own.

Does anyone know where there is a hole in the firewall already on my car or where I should drill one? I'm not exactly sure what the firewall is in my car either and how I should go about drilling one if nessecary. I was assuming the firewall was just the wall between the engine compartment and the interior of the front of the car.

Also if anyone has any tips or help on installing AMPs and Subs in Volvo's I'm sure it would be new to me.


All your help is greatly appreciated.

Thanks,
Trevor






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help with installing power to Amplifier through Firewall on 1989 Volvo 240 [200]
posted by  phishie  on Wed Apr 2 08:48 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.