Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oil leak fix(try again) 700

posted by  someone claiming to be jonnyb on  Tue Apr 15 05:45 CST 2003 [RELATED]

Just replaced the 2 "O" rings on the oil filter extension. Has anyone run into these problems do this job?
1) The "O" ring nearest the oil filter has to be stretched to make it fit in the groove.
2) The FAQ says to use a 30mm deep socket to remove the nut under the filter. Didn't even want to attemp with the 30mm socket way to sloppy. It must be a 29mm deep. Didn't have one so used a 1 1/16" which was still a little sloppy but much better than the 30mm.

Now the question. Have one very small leak remaining the oil is leaking where the oil cooler tube meets the first fitting. This fitting then goes into another fitting which screws into the extension. What am i going to run into when i seperate these fittings at the next oil change? An "O" ring, a gasket, or just a flared tube end? Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil leak fix(try again) [700]
posted by  someone claiming to be jonnyb  on Tue Apr 15 05:45 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.