Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing Hall Sensor plastic connector 200 1986

posted by  yrots on  Thu May 1 14:18 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 12 11:19 CST 2014
[RELATED]

Isolated no spark condition to being a grounded Hall sensor against the distributor because of a broken plastic connector (dead for a $6 piece) I have removed the 3 wires from the old connector and vacuumed out the remaining broken pieces in the distributor. To install the new connector do I need to remove remove the hall sensor. It appears to be held in by 4 screws. Do I remove these screws lift up the interior of the distributor, install the wires in the connector and slide the connector down? I'm afraid to force the connector in from the side for fear of breaking it (with my luck).

86 240 185k
Dirk Story






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing Hall Sensor plastic connector [200][1986]
posted by  yrots  on Thu May 1 14:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.