Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Stripped an acorn nut on the coner of the valve cover near firewall... 200 1990

posted by  KarmaticLove on  Sat May 3 10:36 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Gentlemen,
I was replacing the ground strap, which goes from the firewall to the valve cover, and semi-stripped the acorn nut. Who the hell uses cheesey acorn nuts as hold downs? Volvo, of course!
I am totally pissed off because some simple, bullshit project magnified itself by the power of two. I was able to remove the next acorn nut in line and connect the strap to a "new" location, but would like some help/advice regarding the removal of the stripped nut.
The nut is so close to the firewall I can not get a wrench on it, and my 10mm socket and super shorty extension does not work either. Any advice?
Thanks, Jon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Stripped an acorn nut on the coner of the valve cover near firewall... [200][1990]
posted by  KarmaticLove  on Sat May 3 10:36 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.