Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Weird hood problem 200 1983

posted by  someone claiming to be djriverdance on  Mon May 5 06:02 CST 2003 [RELATED]

I replaced my old rusty hood with a non-oxidized part from a junkyard. Bolts fit OK, then closed carefully.

Problem: when I pulled the cord and let go of the hood pin, I could not lift the hood at all.

After using a thin wrench to unbolt the new hoodpin assembly, I put in the old hoodpin assembly and the hood would not open. Mind you, when I pulled the cord, the hood would jump up an inch or two but I could not get the thing fully open.

At least, until I unbolted one of the bolts. Now it works just fine.

What happened?

(No, this is not a Car Talk puzzler. Though, it could be!!)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Weird hood problem [200][1983]
posted by  someone claiming to be djriverdance  on Mon May 5 06:02 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.