Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

how is the gear shift stick removed? I want to insert the foam donut for noise control 200

uid 4433's pic
posted by  patrick of montreal on  Mon May 12 01:18 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 08:25 CST 2014
[RELATED]

'82 245 with manuel(o.d.). I want to insert the noise insulating foam pad between the tranny and the top of the tunnel. I am changing my support bearing so the driveshaft will be out. I was wondering if it's possible to remove the stick shift at this point so that I could lower the tranny a bit and get the foam donut in. I don't have any diagrams of the stick and it's attachment mech., any and all input welcome, Thankx patrick.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New how is the gear shift stick removed? I want to insert the foam donut for noise control [200]
posted by  patrick of montreal  on Mon May 12 01:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.