Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Question: Doing cam gasket and seal 200 1989

posted by  greg_mustang on  Wed May 14 04:23 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

240 DL sedan B230F '89

I was doing the cam cover gasket and rear seal this morning...

I am planning on putting a bit of gasket sealer on both sodes of the gasket for sealing...

1.. How long should I wait for this to dry before driving the car?

2.. Torque the nuts?

3.. I popped out the rear seal and noticed it is hard as a rock... I though this was upposed to be hard rubber. I guess it is aged. Should I bother getting a new one, or just re-use the existing one with gasket sealer? I need to get a lift to the dealer to pick one up...

Thanks in advace,
Greg Mustang
Montreal - Ottawa
Canada






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question: Doing cam gasket and seal [200][1989]
posted by  greg_mustang  on Wed May 14 04:23 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.