Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't get rid of heat shield rattle 700

posted by  vinraz on  Tue May 20 21:56 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jan 11 13:25 CST 2012
[RELATED]

I am going nuts trying to eliminate a rattling heat shield on my 745 turbo. The bolts are tight, I have new engine mounts, and have tried stuck various thicknesses of steel bar as shims in quite a few places to make the thing tight.
They vibrate upon acceleration at about 1800-2300 rpm, cold or hot. I have also tie wrapped sections of gas line at various points on the trans lines where they might touch any metal so I know it's not them. I live in California, so the shields are necessary to pass the visual part of the smog check. Right now I'm thinking they come off, then go back on only to pass the test in nine months. Unless anyone has some idea I haven't thought of.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can't get rid of heat shield rattle [700]
posted by  vinraz  on Tue May 20 21:56 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.