Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

end link bushing removal?? 200

posted by  760 on  Sat May 24 04:09 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Nov 8 18:16 CST 2010
[RELATED]

Does any one know how to get the end link bushings out of the end link? The ones going into the control arm area? They are pressed in but there is no ridge to use to press them out with. I am afraid to put all the weight of the press on the stem of the link while using the press, it might bend the link.


I am putting turbo sway bars on my 240 and have bought the IPD bushing set including the extra poly bushings that connect the link to the arm.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New end link bushing removal?? [200]
posted by  760  on Sat May 24 04:09 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.