Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Stupid bolt.. trying to replace gaskets.. 200

posted by  phishie on  Sun Jun 15 07:06 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Ok so the gasket between my exhaust down pipe and the exhaust manifold is leaking. So I've got my brick up on ramps and I get the first two bolts off that hold the down pipe to the manifold. There is one bolt left and I can't get it off for the life of me.

The problem is there is hardly any space around it to turn a wrench or ratchet. The bolt Im talking about is the one that is on the rear side of the down pipe where there is only one bolt. The other bolts were on the front side and there were two bolts on that side.

I'm using PB Blaster to help loosen up the rust etc. Any suggestions on how to get this bolt off?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Stupid bolt.. trying to replace gaskets.. [200]
posted by  phishie  on Sun Jun 15 07:06 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.