Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

STEVE RINGLEE - 2nd OPINION - PLEASE 700 1992

Steve,
I think that was you that responded to my question a few days back on the head gasket - so I need your extended opinion, please. (other opinions welcome too)

What happened:
It ran hot - 5 minutes or so.
Mechanic said I was lucky - seemed to be OK.
Now seems to have less power.
You said it may have cooked a head gasket - probably not a warped head.

Now - today:
I found a small trail of coolant down the side of the block about 2-3" back behind the water pump (pass side)
Called my mechanic.
He said 1000.00 - for totally reworking the head (the only way he does it) - comments that the head WILL be warped.

I do not have a grand. My wife would faint.

Question:
With 170K (mostly highway) could I be safe just to try nothing more than a gasket set - and if not, what would you say might be the least I might have to go for.

Thanks for your help
Andrew in AL



--
'92 745T (170K)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New STEVE RINGLEE - 2nd OPINION - PLEASE [700][1992]
posted by  Andrew in AL subscriber  on Tue Jun 24 01:51 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.