Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

virgo wheels, wheel hub pin 200 1989

posted by  someone claiming to be greg_mustang on  Tue Jul 15 17:46 CST 2003 [RELATED]

Recently I aquired a set of virgos from Rhys in Vancouver, thnaks Rhys the wheels are great.

I noticed today after taking off one of the wheels that the hub pin was bent and actually dug a whole at the back of the wheel... and the brake disc was hence warpped.

Looking at the wheel it is obvious that the pin was too long for the whole at the back of the wheel... about 2 of my four virgos have tis issue, the othe rhave deeper holes...

Is this normal? Did they change sometime in the later 200 series years? Should I just emove the pin, or replace it with a screw? Should I cut down the pin?

Oponions? Experiences?

Thanks in advance.
Greg





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New virgo wheels, wheel hub pin [200][1989]
posted by  someone claiming to be greg_mustang  on Tue Jul 15 17:46 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.