Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Where do I go from here--Mass Flow Sensor 200 1986

posted by  cjeden on  Thu Jul 31 03:38 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello all-I'm a complete newbie here.

I have a 1986 Volvo 240 Wagon -odometer broke at 117,000 that was six years ago--the car is great and is used mainly for Home Depot runs--have been able to drive home 16 foot lengths of pressure treated lumber in the back of this puppy.

I recently replaced the Mass Flow Sensor--but I still can't get the engine to start--it's cranking but doesn't catch. My question is what should I investigate next--- I know it's a huge question -- however, I'm a virtual freshman when it comes to fixing cars but I'd like to learn more and this volvo will be where I practice--I guess I'm wondering what I should check next.

Any advice would be great

thanks again

cje






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Where do I go from here--Mass Flow Sensor [200][1986]
posted by  cjeden  on Thu Jul 31 03:38 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.