Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Should I use this heater control valve? 900

posted by  dm960 on  Wed Aug 6 22:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:41 CST 2014
[RELATED]

I get most of my parts from an independant mech.(used to work at dealer)and he only uses quality parts and sometimes only volvo in certain areas.this past weekend I replaced oil cooler coolant hoses,thermostat,coolant and was about to put on the vavle but it looks a bit different from the original and it's all plastic,I wanted to replace while I had the cooling down and didn't because of the difference,I called him to see if he had the original style but this the one he uses on all replacments. just checking to see if anyone has tryed this type.Of course it means draining the system again.I beleive his parts come from world pac and I've never had any problems from previous parts and it's always cheaper than the dealer.Thanks Dave
--
83 242 DL , 92-965, 94-965






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Should I use this heater control valve? [900]
posted by  dm960  on Wed Aug 6 22:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.