Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2016

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tail shft bushing orientation

posted by  PropMgr on  Sat Aug 9 12:19 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am replacing the tail shaft bushing on a '87 740 turbo. I have removed the tail shaft and am ready to install the new bushing but the new bushing is different from the old. The the new bushing has a hole and grooves. The old bushing has grooves but no hole. Should the hole in the new bushing align with the one of the two grooves in the tail shaft housing? One groove is larger than the other. Logic says to align the hole with the smaller of the two grooves in the tail shaft housing.

I have replace all of the universal joints and center support bearing so I really don't want to pull the drive shaft again.

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tail shft bushing orientation
posted by  PropMgr  on Sat Aug 9 12:19 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.