Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2008

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Question: thermostat install - gasket sealant required?? or not???

posted by  Goldy on  Thu Aug 21 08:51 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am putting in the thermostat on my B21A 78 242.

The thermostat comes with a rubber gasket that stretches around the thermostat flange and sits inside the recessed lip on the thermostat housing.

I am not sure if additional RTV sealant (silicone product) is needed in addition to the rubber gasket, or just install with the rubber gasket.

There is no fibre gasket like we used to install.
There was some black siliocne sealant sticking the housing to mating face on the block, but it made remaoval of the housing difficult.

What is the correct method???

Thanks in advance...





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question: thermostat install - gasket sealant required?? or not???
posted by  Goldy  on Thu Aug 21 08:51 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.