Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Installing OEM front armrest...did I bust something 200

uid 13259's pic
posted by  Sterndogg02 on  Sat Aug 23 09:25 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hey all,
In my attempts to install the front armrest I think I busted something internally. The seatbelt bolts were extremely tough to unscrew and as a result I placed a lot of pressure on one of them and suddenly the right one became quite loose, but now I can't remove it and it won't screw tightly back into place. Before doing anymore damage did I strip the bolt or is something really messed?? I can hear it touching metal but again won't tighten.
Thanks!
-Adam
--
'92 244GL silver-metallic, 146k, Bilstein HDs, IPD sways, upper+lower chassis braces, Cherry-Turbo strut brace, 240 OEM rear wing, 15" Draco Rims, Full E-code lighting w/side repeaters, Magnaflow 2.5" mandrel SS exhaust w/Unitek header (Jethot coated)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing OEM front armrest...did I bust something [200]
posted by  Sterndogg02  on Sat Aug 23 09:25 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.