Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ball Joint Stud Nut w/ or w/o washer?? 200 1988

posted by  Sleepy on  Mon Aug 25 16:07 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I'm in the middle of a front suspension do over, bushings, tie rod ends, ball joints. When I removed the ball joints, I found a washer under the stud retaining nut on the right side. No washer on the left side. The washer I found on the right side has been squashed pretty good. Of course the new ball joints came with bounting bolts and stud retaining nuts, but no washers.

Should the ball joint studs be connected to the stut mounting plates with washers or just the included retaining nuts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ball Joint Stud Nut w/ or w/o washer?? [200][1988]
posted by  Sleepy  on Mon Aug 25 16:07 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.