Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Plastic vs Metal A/C Low Pressure Switch 900

posted by  batbrick on  Wed Aug 27 16:12 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Feb 14 00:48 CST 2007
[RELATED]


Hello all. My wife's 94 945 has a chronic slow leak at the A/C low pressure switch. (Verified by UV dye.) I have replaced the o-ring quite a few times with slightly thicker ones and it always leaks. The switch has a plastic "sleeve" that the threads are in, and this plastic sleeve is what screws onto the receiver/dryer fitting. There is no damage to the receiver/dryer fitting threads, nor to the threads inside the sleeve. I noticed that my 94 944 has a metal sleeve on the low pressure switch instead of a plastic one, so I was wondering if it is possible that the plastic sleeve on the leaking one is stretched or something (meaning it will never seal.) Has anyone run into this? The switch works perfectly, so I'd hate to replace it if I am not sure that this could be a problem... Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Plastic vs Metal A/C Low Pressure Switch [900]
posted by  batbrick  on Wed Aug 27 16:12 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.