Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2017 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear support arm bushing - HELP 120-130

posted by  timbert on  Sun Sep 7 15:01 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 13 05:52 CST 2001
[RELATED]

I can not get the new blue poly rear-support arm rear bushing on my '66 122. I was able to get all the others off & replaced on one side, but try as I might I can not get the great big doughnut one that clamps onto the axle at the support arm

(item G in the linked IPD diagram )

http://www.ipdusa.com/images/Categories/RearWheelDrive/1221800rear2.jpg

when I wrap the new bushing around where it belongs - the two ends of the bushing are well over an inch apart ... it looks like it is seated in the channel as well as it can go. no matter what i've tried, i can not get it compressed enough to get both bracket bolts on - I can get one or the other, but never both.

any advise/thoughts/suggestiong/etc that could help me get the back-end back on the ground & Ursula back on the road will be much appreciated.

thanks

tim





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear support arm bushing - HELP [120-130]
posted by  timbert  on Sun Sep 7 15:01 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.