Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

O2 Sensors for 940 w/Bendix Regina 900 1994

posted by  someone claiming to be WhiteFox on  Sun Sep 14 05:56 CST 2003 [RELATED]

Results of experimentation with O2 sensors for this vehicle with Bendix/Regina system. These cars have one sensor in the cat. The generic Bosch 3 wire sensor did not make the ECU happy. On a scope, the voltage did swing, but only sluggishly and it did not vary at all at idle. Car ran very well, however; engine code for O2 sensor kept being set. Ordered OEM part from Brentwood Volvo; the part number is 3547445. The unit is stamped NTK A4F (made by NTK in Japan), and comes with the original 4 pin harness plug. OEM part makes the ECU happy and no codes are set. Oxygensensors.com lists an OEM replacement unit, part #250-23080 that has the same 4 pin plug on the harness, but did not try this last part out. At 1/2 the price of the Volvo part, someone should give it a try, however. Thanks,
-WF






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New O2 Sensors for 940 w/Bendix Regina [900][1994]
posted by  someone claiming to be WhiteFox  on Sun Sep 14 05:56 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.