Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Do you have to use the bushing tool to get the trailing arm bushing replaced? 200

posted by  Strackerjack on  Tue Nov 4 01:31 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 19:11 CST 2014
[RELATED]

I'm about to attack the tailshaft bushing, and center support bearing on Bad Blue so I figured I might as well take on the rear trailer arm bushings as well.

since I will probably be going to the machine shop for the tailshaft bushing and the center support bearing ... is there anyway to have the machine shop do the trailer arm bushing as well or is that one too hard to remove from the car to take to the shop?

looking forward to a quieter, smoother less klunking ride,

jack
--
Bad Blue, '86 245, 258,000 mi., Columbus, Ohio






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Do you have to use the bushing tool to get the trailing arm bushing replaced? [200]
posted by  Strackerjack subscriber  on Tue Nov 4 01:31 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.