Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Coolant Temp Sensor 200 1981

posted by  sejose on  Mon Nov 17 13:14 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi again

I've been trying to troubleshoot my new 81 245, shaky idle, and the smog test revealed max HC emissions. So far I have found a couple vacuum leaks, and I've changed the injector seals, new rotor and cap, but the shaky idle is still present. Car is not missing, starts and runs very well. This evening I removed and tested the coolant temp sensor, and it appears to give an errant ohm reading. I get 52 ohms across the terminals on the sensor. Heat the sensor in a pan of water to boil, and the reading changes by only a few ohms.

So I'm guessing this is my problem. High HC reading because the constant idle system is receiving errant info. This might also explain the shaky idle, and the fact that I don't get a cold high idle.

I suppose then my question is why didn't the check engine light signal an error? Or is the 81 with K-Jet (non turbo) not capable of such self diagnostic?

Thanks

Scott in Auburn, California






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Coolant Temp Sensor [200][1981]
posted by  sejose  on Mon Nov 17 13:14 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.