Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

strut mount bearings vs. mount bushing - how do I test? 200 1981

posted by  diy 101 on  Mon Dec 1 04:42 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi ya'll - lost my last post. sorry if this is a duplicate. Is there any test I can do to see if it's my upper strut mount bearings or my upper mount bushing that's bad? (Given my luck it's both!) The bushing should probably be replaced anyway. It's dry and pulling away. I found the strut inserts I need and the upper mounts, but no source yet for the rubber bushing unless I don't recognize what it's being called online (tried ipd, fcp groton, eeuroparts.) Any suggestions for a supplier?

--
thanks everyone for all your help






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New strut mount bearings vs. mount bushing - how do I test? [200][1981]
posted by  diy 101  on Mon Dec 1 04:42 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.