Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bolt tightening sequence for timing cover 700 1991

posted by  ranblacks on  Sat Dec 6 10:04 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Is there a particular tighten sequence to follow in replacing the timing cover?

I have taken off the timing cover to change the crank and intermediate seals. Everything went back together okay, but the intermediate shaft will not turn now that it's all tightened down (even with the gear on turning by hand). I loosened all the bolts back up, then it turns freely, like it should. I tried different sequences, but nothing else but looseneing all bolts will free it. What else could be binding?

Thanks in advance;
randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bolt tightening sequence for timing cover [700][1991]
posted by  ranblacks  on Sat Dec 6 10:04 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.