Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removal of old radio/casette and installation of cd player 200

Hi Guys,
I am planning to remove the old radio/tape player in my 200 series and replace it with an Alpine CD player sometime soon (1982 242 with 75 amp alternator). Can you advise me on a few points?

First, are there any tips or steps that I should keep in mind when removing the old radio/tape deck? (I will disconnect the battery and check the Haynes and Bently manuals again -- they don't appear to have a lot to say).

Second, are there points that I should keep in mind if I am going to try to install the cd player with --- probably something like an aftermarket wiring harness and faceplate?

Third, should I consider replacing the existing front door speaker wire with a heavier guage or newer wire? I have not checked closely but they appear to be in pretty good shape (no rust or corrosion evident).

I'll come back for advice on tips for the installation and wiring for the rear shelf speakers once I get this job completed. Thanks!

Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removal of old radio/casette and installation of cd player [200]
posted by  someone claiming to be Dave  on Thu Jan 1 12:33 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.