Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

any other sources of driveline vibration other than Tailshaft bushing and Center bearing? 200 1986

posted by  Strackerjack on  Mon Jan 5 02:55 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 19:11 CST 2014
[RELATED]

I'm really bummed that after replacing my Tailshaft bushing and my Center Support bearing there is still vibration from what I think is my Drive Shaft.??

I believe that I realigned my driveshaft correctly... the front U-joint and the rear U-joint are parallel, the marks I made between the shaft and the output flange were realigned... maybe the previous owner misaligned them and I put it back together in the same misalignment?

is there any other place this vibration could be coming from?

The vibration goes away when I let off the accelerator pedal, and it seems speed dependent.

it has been lessened somewhat by the recent work but I was really hoping it would all be gone!

any thoughts would be appreciated greatly.

by the way the info. received here really helped the work go smoothly... thanks!

jack
--
Bad Blue, '86 245, 260,000 mi., Columbus, Ohio






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New any other sources of driveline vibration other than Tailshaft bushing and Center bearing? [200][1986]
posted by  Strackerjack subscriber  on Mon Jan 5 02:55 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.