Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

'86 245DL Idle mix - O2 sensor voltage doesn't budge 200

uid 17010's pic
posted by  tvg on  Thu Jan 15 10:47 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 21 14:10 CST 2007
[RELATED]

When hooked up, the O2 sensor cycles from low to high as it should in closed loop operation - ie. ~.3 V to ~.7 V. When I disconnect the O2 sensor the voltage stays at .524 V even when I turn the idle mix screw on the AMM. Coincidentally with the AMM and the O2 sensor disconnected the O2 sensor reads .521 V. I am able to adjust the idle mix as outlined in Bentley with a dwell meter, but am curious about the lack of effect on the mix in open loop operation. I have tried two different AMMs with the same result. Also the fuel pump, filter and pressure regulator are new. I've checked at the ecu that there is connection to the AMM. I don't know the age of the O2 sensor. The temp sensor resistance behaves qualitatively as it should, but I haven't tested it for accuracy.
Thanks for any help you can provide.
Tom





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '86 245DL Idle mix - O2 sensor voltage doesn't budge [200]
posted by  tvg  on Thu Jan 15 10:47 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.