Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fan only works at max speed 200

Hi all.

I went out for lunch an hour ago and cranked up the old 245ti and the fan was blowing at max speed. The switch was on "1". I moved the switch through it's four positions and it had no effect. I tried sliding the switch in between speed settings which normally kills the fan completely but that didn't do anything either. The switch is completely inoperative.

I've searched the board (there's even been a post today about the resistor) but so far I've only found people who have lost fan function in the lower settings. I didn't find a post from anyone who had the fan blowing at max regardless of switch settings. Maybe I missed them or I've been using the wrong search terms.

Anyway, as it only just happened, I haven't even been able to pull the dash and check the switch for something obvious (I will at home tonight). I just figured I'd go ahead and post in the event someone might know just what it is. Would switch failure or the switch wires being pulled loose cause this?

As always, thanks in advance for the feedback.
--
Eric Carter - 1982 245T, M46






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fan only works at max speed [200]
posted by  ecarter  on Thu Jan 22 08:28 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.