Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2011 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Head skimming - how much to take off? 120-130

posted by  Aidan on  Thu Jan 29 10:18 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 03:47 CST 2014
[RELATED]

Hi,

Following on from my post about performance enhancements and from the advice that I received I've decided to go with the twin SUs, D cam and a head skim to increase the compression ratio from the standard B18A 8.7:1. The head height of the B18A head is 88 mm (3.46 inches - more than any B20 head). The people who are to skim the head are offering a choice of 87 mm (B20F spec), 86.2 mm (B20B spec) or 83 mm (lower than B20E spec). 86.2 mm is the spec of the B18B type 2 head which should be the same as the 123GT spec (10:1 compression ratio). Is bring it down to 83 mm going too far given that it'll be running on unleaded fuel or are there any other disadvantages?

Thanks in advance for any advice/opinions,

Aidan
--
1967 131, 1969 131






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Head skimming - how much to take off? [120-130]
posted by  Aidan  on Thu Jan 29 10:18 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.