Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How do you remove the torque converter from the flywheel?(AW70) 200 1985

Hello Brickers.

I found a low mileage AW70 in a Pick and Pull yard last week and removed it but I ran into a slight problem.

How do you remove the torque converter?

I can't find this information in any of my manuals and it really has me puzzled.
I laid there for fifteen minutes trying to figure it out.

I ended up leaving it there and I am going to use my old one but I would like to install it before putting the trans in.

Would it be easiest to just leave it attached to the flywheel and just be careful not to damage the front seal in the trans.? (I plan on replacing the front seal)

It really seems odd. I have never seen this type of setup before.

Thanks in advance for any help on this.

Kyle245






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do you remove the torque converter from the flywheel?(AW70) [200][1985]
posted by  Kyle245 subscriber  on Wed Feb 18 03:36 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.