After 3 months i finally found time to put the 745 back togehter [clutch job with some other work].

I went to start it up. No click, nothing, not even from the starter solenoid.

Figured I could put in a spare starter, took all of 10 minute so why not.

Still no luck. Jumper wire from + terminal of the battery to starter works.

The little trigger wire, has no juice going to it.

Also, while cranking to get the motor to start, no fuel pressure registered on my aftermarket gauge on the rail [my fuel pumps come on with the key in the on position].

I replaced the ignition switch, no luck either. The battery terminals are very clean, and the bay itself is...

The battery also registers over 12V at the terminals...so i can rule that out..

Any thoughts?

Dan