Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

F. Rotor Repl. (1 pc) Prob. Fitting inside bearings onto aftemarket (CTC) Rotor? 700

posted by  Coldbrick on  Mon Mar 15 11:20 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello,
After the saga a locating parts, freeing guide pins etc. I have begun to reassemble the front brakes (Girling) on my 87 745Ti. I have the 1 piece hub and rotor type. My problem is with replacing the race bearings on the inside portion. I popped them out of the old ones and the retaining ring the follows the bearing itself does not fit right. It seems the inside diameter of the back of the rotor is about 1/3 inch too large so that the ring does not snug up into it tightly. Has anyone else ever had this problem and is there a solution or can I just reassmble like this? This is the only rotor stocked for this make at the parts store, which was Canadian Tire and the mfg. of the rotor is Eurorotor.
All help gratefully accepted!!!!

Mike






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New F. Rotor Repl. (1 pc) Prob. Fitting inside bearings onto aftemarket (CTC) Rotor? [700]
posted by  Coldbrick  on Mon Mar 15 11:20 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.