Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Similarity between 140 and 240 floor pans? 140-160

posted by  someone claiming to be Pnoder on  Thu Mar 18 08:32 CST 2004 [RELATED]


I have an '85 244 Ti in the garage with a badly rusted floor and a 144 headed for the crusher out in the driveway with a pretty solid floor....

I've got the front seat mounting area removed from the 244 now so that the whole of the floorpan is exposed inside the car....I'm wondering if the 144 will be "close enough" that I could just cut out the sections I need (pretty much the outer 3rd of the floor on both sides from the midpoint between the rocker and tranny tunnel to the rocker on both sides, front to rear...mostly) from the 144 and graft them in.

The seat mounting area was not too bad to take out btw. Lots of spotwelds to drill out and I found a few more as we were pulling it out but all in all not too bad.

Thanks for your input,

Pnoder






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Similarity between 140 and 240 floor pans? [140-160]
posted by  someone claiming to be Pnoder  on Thu Mar 18 08:32 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.