Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing plastic fuel line from filter outlet to injection rail - anyone done this? 200

posted by  someone claiming to be 12AX7 on  Fri Mar 19 16:18 CST 2004 [RELATED]

This winter has (for some reason) resulted in a few pinhole leaks in the rigid plastic fuel line that leads from the filter outlet to the rail. I plan to replace the entire run of plastic line with SAE30R9 grade rubber injection hose.

My biggest question is how to secure the hose the undercarriage of the car - can I just cable-tie it off every few feet? Also, should I spray that chassis "tar-protection" stuff on the hose once it's on secure?

If anyone has done something similiar and would offer a few tips, I would greatly appreciate it.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing plastic fuel line from filter outlet to injection rail - anyone done this? [200]
posted by  someone claiming to be 12AX7  on Fri Mar 19 16:18 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.