Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Power window regulator replacement 700 1992

posted by  Kaz on  Tue Mar 30 02:18 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Feb 23 03:37 CST 2008
[RELATED]

I just aquired a 92 740 wagon. The driver side power window did not work which I knew about. I hoped for a bad switch or something simple. Upon removal of the door panel it is obvious a PO or his mechanic wired (I'm talking coat hanger) the window transmission to keep the window closed. The window motor will run but nothing happens. I picked up a motor/regulator from a pick and pull from a 91 740. It was held on by four studs. To my surprize the one on my 92 is riveted on. Appears the rivet spacing is the same as the stud pattern on the pick and pull motor/regulator. My question is if I drill out the rivets will the 91 motor/regulator fit and connect to the window?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Power window regulator replacement [700][1992]
posted by  Kaz  on Tue Mar 30 02:18 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.